Premier Mounts MAG-FCTA Installation Manual download pdf (Page 5)

MAG

Installation Manual Page - 5 -

Attaching the Mount

Unpack the MAG Mount

and review any WARNING statements that apply to the installation. Select the desired

location for the MAG Mount.

1. Locate the mounting points on the bottom of the projector

(see arrows above for mounting point recognition).

NOTE

: Projector mounting points will vary. The projector

used in this manual is an example, and may not match

yours exactly.

2. Attach the appropriate number of mounting legs to the

projector using the appropriate mounting hardware

(see Page 4, Selecting the Proper Mounting Hardware).

3. Do not tighten these screws completely at this time.

4. Align the projector plate to the mounting legs.

5. Position the legs accordingly for best configuration. You

may raise or lower each leg independently by turning the

leveling barrels.

6. Secure the legs to the projector plate by screwing

M6 x 12mm security screws into the M6 square nut (do not

overtighten) on the mounting legs.

7. Tighten all security screws at this time.

8. Once the security screws have been tightened, place the

plastic cap over each leveling barrel and firmly push the

plastic cap into place.

Single Mounting Point Installation

If your projector has a ¼-20 x 5/16” mounting point, please refer

to the following three steps:

1. Determine where the mounting point is located.

2. Place the projector plate over the mounting point.

3. Insert the ¼-20 x 5/16” security screw.

NOTE

: This screw will use a standard hole when mounting.

¼-20 x 5/16” Mounting

Screw

Mounting Point

Standard Hole

1 2 3 4 5 6 7 8

No comments

Premier Mounts MAG-FCTA Installation Manual Page 5