Premier Mounts Universal Flat-Only Mount UFM User Manual download pdf (Page 11)

PTM / PTM-B

Installation Instructions Visit the Premier Mounts website at http://www.mounts.com Page 11

Attaching the Flat Panel to the Mount

Attaching the Mount to the Wall Plate



Insert two (2) M4 x 5mm Phillips screws to the top two mounting points of your ﬂ at panel. Thread the M4 x 5mm

Phillips screws halfway into the ﬂ at panel, but do not tighten the screws at this time.

If you are using the UFP-280 Adapter Plate, you can use either of the A or B mounting points. Refer to the

“Technical Speciﬁ cations” section for UFP-280 Adapter Plate mounting points.



Insert the heads of the M4 x 5mm Phillips screws through the keyhole slots.



Insert two (2) M4 x 5mm Phillips screws into the bottom mounting points.



Tighten all M4 x 5mm Phillips screws.

Do not overtighten the mounting hardware.

Proceed to the “Attaching the Mount to the Wall Plate” section.

Flat Panel without UFP-280 Adapter Plate Flat Panel with UFP-280 Adapter Plate

Your PTM mount must be attached to the back plate that is secured to

the wall. The back of your PTM mount has a built-in bracket designed to

“hang” on the wall plate.



Lift your PTM mount up to the wall plate.



Slide the top of the PTM mount on to the top of the wall bracket.



Pivot the bottom of the PTM mount towards the wall plate until it

rests against the wall.

Do not release the PTM mount until you are certain that it is resting

securely on the wall plate.

Proceed to the “Securing the PTM Mount” section.

Wall Plate

PTM Mount

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Premier Mounts Universal Flat-Only Mount UFM User Manual Page 11