ECM-D70T / ECM-D70T1.5
Page 8 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions
Flat Panel
Griplate™ Washer
Nylon Spacer
Mounting Bracket
Mount Point
Mounting Screw
Griplate™ Washer Installation
Premier Mounts’ Griplate™ Washers are designed to
accommodate the various M4, M5, M6 and M8 hole
sizes required by at-panels.
For Griplate™ installation, the dimples must be
facing the at-panel for the lower mounting points.
For the upper mounting points, the dimples must
be facing away from the at-panel.
Do not place excessive pressure on the back of
the at-panel, as this may damage your at-panel.
The Griplate™ Washer must be installed between
the head of the mounting screw and the mounting
bracket as shown.
Does your at-panel have:
● Recessed mount points?
● Uneven mount points?
● A curved back?
● Any obstruction near the mount point?
If Yes, you must install nylon spacers. Remove the
mounting brackets, Griplate™ washers, and mounting
screws from the back of the at-panel. Proceed to the
“Nylon Spacer Installation” section.
If No, skip to the “Flat Panel Installation” section.
Nylon Spacer Installation
Premier Mounts’ nylon spacers allow you to attach the
mounting bracket to at-panels which have recessed
or uneven mount points. Each nylon spacer will add
distance between the mounting bracket and your at-
panel.
The nylon spacers must only be installed between
the mounting bracket and your at-panel.
The nylon spacers will t M4, M5, M6 and M8 screw
sizes.
Proceed to the “Flat Panel Installation” section.
M8
M6
M5
M4
Comments to this Manuals