Premier Mounts ECM-D70T Specifications download pdf (Page 9)

ECM-D70T / ECM-D70T1.5

Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 9

Flat-Panel Installation

Do not release the at-panel until the mounting

bracket arms are fully resting on the elliptical

mounting bar.

Install the mount according to the instructions

provided by Premier Mounts. Perform all structural

reinforcements before attaching the at-panel to

the ceiling mount.

Raise the mounting bracket arms and the attached at-

panel over the elliptical mounting bar of the

ECM-D70T.

Lower and center the mounting bracket arms with the

attached at-panel onto the elliptical mounting bar of the

ECM-D70T.

Mounting Bracket Arms Elliptical Mounting Bar

Do not release the at-panel until the mounting

bracket arms are resting fully on the elliptical

mounting bar.

Step 1

Step 2

The cable access ports face the rear of the at-

panel. It may be easier to pre-wire any cables

prior to at-panel installation (see Page 10).

Step 3

➊

On each mounting bracket arm, insert and tighten

an M6 x 25mm Pan Combo screw in the larger

mounting hole.

➋

Repeat the Flat-Panel Installation instructions for

the other at-panel.

Do not over-tighten these screws.

Proceed to the “Attaching the Decorative Covers”

section.

M6 x 25mm

Screw

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Premier Mounts ECM-D70T Specifications Page 9