Premier Mounts AM50-B Specifications download pdf (Page 12)

AM50

Page 12

Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions

Attaching the Flat Panel to the AM50 Mount

1) Insert two (2) M4 screws into the top two mounting points of your ﬂ at panel or UFP-280 Adapter Plate. Thread

the M4 screws to one-half of their length into the ﬂ at panel or UFP-280 Adapter Plate, but do not tighten the M4

screws at this time.

The length of the M4 screws are dependent upon whether or not you are using the UFP-280 Adapter Plate, as

shown below. Make certain you use the correct length for your speciﬁ c installation.

If you are using the UFP-280 Adapter Plate, use the B mounting points. Refer to the “Technical Speciﬁ cations”

section for UFP-280 Adapter Plate mounting points.

2) Insert the heads of the M4 screws through the keyhole slots.

3) Insert two (2) M4 screws, of the proper length for your installation, into the bottom mounting points.

4) Tighten all M4 screws.

Do not overtighten the mounting hardware.

Proceed to the “Adjusting the AM50 Mount Tension” section.

Flat Panel without UFP-280 Adapter Plate Flat Panel with UFP-280 Adapter Plate

Thread Insert in Flat Panel

or Adapter Plate

AM50 Mount

Keyhole Slot

M4 Screw Partially

Threaded Into Flat Panel

or Adapter Plate

M4 x 5mm ScrewM4 x 10mm Screw

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Premier Mounts AM50-B Specifications Page 12