Premier Mounts AM50-B Specifications download pdf (Page 13)

AM50

Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 13

Adjusting the AM50 Mount Tension

Joint Tension Nut

Adjusting the Swingout Arm Tension

Adjusting the Tilt/Pivot Tension

Your AM50 Articulating Swingout Arm ships from the

factory pre-tensioned. However, you can make ﬁ ne-tune

adjustments to how much pressure is required to move

each section of the swingout arm by adjusting the three

joint tension nuts.

1) Remove the plastic joint caps from the bottom of each

of the swingout arm joints.

2) Use a socket wrench and the supplied 14mm socket

to loosen or tighten the joint tension nut located on

the underside of each swingout arm joint.

Turn the joint tension nut clockwise to increase

tension.

Turn the joint tension nut counter-clockwise to

decrease tension.

Do not overtighten the joint tension nuts.

Do not completely remove the joint tension nuts.

3) Replace the plastic joint caps.

You can adjust the tension of the Radial Glide™ ﬂ at panel

attachment head by adjusting the tilt/pivot tension nut.

1) Remove the plastic tilt/pivot cap on the back of the

tilt/pivot head.

2) Use a socket wrench and the supplied 14mm socket

to loosen or tighten the tilt/pivot tension nut.

Turn the tilt/pivot tension nut clockwise to increase

tension.

Turn the tilt/pivot tension nut counter-clockwise to

decrease tension.

Caution!

Loosening the tilt/pivot tension nut too much may

cause the ﬂ at panel to suddenly tilt forward.

Do not overtighten the tilt/pivot tension nut.

Do not completely remove the tilt/pivot tension nut.

3) Replace the plastic tilt/pivot cap.

Proceed to the “AM50 Cable Management” section.

Radial Glide™ Head

Tension Nut

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Premier Mounts AM50-B Specifications Page 13