Premier Mounts AM50-B Specifications download pdf (Page 9)

AM50

Installation Instructions Visit the Premier Mounts website at http://www.premiermounts.com Page 9

Step 4

1) Place the wall plate against the wall over the

threaded shafts of the concrete wedge anchors.

2) Attach the nuts and washers to each of the concrete

wedge anchors and tighten using a socket wrench

and an M10 socket.

Do not overtighten the wedge anchor nuts.

Proceed to the “Mounting Hardware” section.

Installing the Wall Plate (cont’d)

Mounting Hardware

Selecting the Mounting Hardware

1) Insert the Thread Depth Indicator into the thread

inserts found on the bottom or top of the ﬂ at panel.

2) Use a pencil to mark the depth of the thread insert on

the Thread Depth Indicator, as shown in Figure 1.

3) Insert the Thread Depth Indicator into the remaining

thread inserts to compare and verify their depth.

4) Locate the correct diameter screw for the thread

insert.

If the screw you selected is longer than the mark on

the Thread Depth Indicator, as shown in Figure 2 and

Figure 3, do not use this screw. The screw length

must not bypass the mark.

5) Test the diameter for each of the screws provided in

the hardware pack.

The correct diameter screws should thread easily into

the mounting point and not pull out when tension is

applied.

Does your ﬂ at panel have:

● Recessed mounting points?

● Uneven mounting points?

● A curved back?

● Any obstruction near the mount point?

If Yes, you must install Universal Spacers. Proceed to

the “Universal Spacer Installation” section.

If No, skip to the “UFP-280 Adapter Plate Installation”

section.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Premier Mounts AM50-B Specifications Page 9